Symptom: On a CIH AccuGuide Ready with a EDX Steer-Ready kit installed, the tractor management center displays a "DIFFLOCK FAULT" or a "MFD FAULT".
Cause: This is caused by the wheel angle sensor "WAS" getting erroneous readings via the tractor management system.
Resolution: When the system is powered on and you get this error immediately shut the system down. Install the second WAS adapter provided in the Steer-Ready kit. If the error persists you can repin the adapter following the install instructions. If you still receive the errors, reconnect the original CIH WAS and an Outback Guidance WAS must be installed as per the hydraulic installation guide.