Symptom: New eDriveXC installation does not pass calibrations during initial setup.
Cause: Occasionally, a new eDriveXC's messages and protocols get disrupted causing the system to fail calibration.
Potential resolutions:
1. Under MENU>VEHICLE PROFILE> CURRENT VEHICLE PROFILE, note the "Valve Type" that is entered, then change "Valve Type" to any other option available. The terminal will prompt you with a warning stating to power cycle your eDriveX (or "ECU"). Using the 3 position rocker switch for the eDriveXC power, turn to the "Off" position, then back to "Auto/Steer" . Once the eDriveXC is communicating with the terminal again, select the original "Valve "Type" and repeat the ECU powercycle process. Once the "Vehicle Calibration" button is available restart the vehicle calibration.
Image of a REBEL prompting a power cycle after a new valve is selected:
If step above does not correct issue:
2. Create a new vehicle profile by pressing MENU>VEHICLE PROFILE>NEW VEHICLE PROFILE. Name this new profile anything you'd like, it just cant be the same as your original profile. Select the new profile as your current profile, enter dimensions, press "Save". Select Current Vehicle profile, and start calibrations from step 1 again.