Kyli Johnson - Outback Guidance
- Total activity 574
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 276
Activity overview
Latest activity by Kyli Johnson - Outback Guidance-
Kyli Johnson - Outback Guidance created an article,
Erase NV Memory - Automate (Video)
Use this process to reset the Automate to default settings and clear any memory-related spray issues. Before you erase the NV memory, record your section widths, either through the S...
-
Kyli Johnson - Outback Guidance created an article,
VSi Troubleshooting Cheat Sheet
VSi Troubleshooting Cheat Sheet Check Integrity of All Connections: Ensure VSi switchbox is connected to the steering wheel. On the EDTC ensure cable 051-0259-000# is connected to the switchbox ...
-
Kyli Johnson - Outback Guidance created an article,
How to configure overlap settings - REBEL
How to Configure Overlap Settings Go into the Overlap Settings menu Implement Profiles > Current Implement > Implement Settings > Overlap Settings % Coverage How far the boom section has to be in...
-
Kyli Johnson - Outback Guidance created an article,
New eDriveXC installation does not calibrate
Symptom: New eDriveXC installation does not pass calibrations during initial setup. Cause: Occasionally, a new eDriveXC's messages and protocols get disrupted causing the system to fail calibration...
-
Kyli Johnson - Outback Guidance created an article,
S-Lite Recovery Software
Use this recovery process to reload S-Lite 1.5 software in the event, while updating to 1.5, the S-Lite screen shows "Load S2 1.4.
-
Kyli Johnson - Outback Guidance created an article,
-
Kyli Johnson - Outback Guidance created an article,
Calibrating Max Touch Screen Version 1.8 Only
Calibrating MAX Touch Screen Download Max boot loader 1.8 software (contact Customer Support via Support@OutbackGuidance.com) Unzip to desktop Save on a clean thumb drive On the Max: Go to Men...
-
Kyli Johnson - Outback Guidance created an article,
S3 update failure
Symptom: S3 failed update, sees warning on screen: "The instruction at 0x004aa2d0 referenced memory at 0x00000038. The memory could not be read". Cause: Possible SBC board failure, or memory card n...
-
Kyli Johnson - Outback Guidance created an article,
-
Kyli Johnson - Outback Guidance created an article,
STX User Guide Supplemental Notes v1.0 to v1.1
This guide only applies to users who have upgraded software versions from v1.0 to 1.1.