Note: Adding an implement involves many steps—many of these involve rate control setup and calibration. If there are time constraints when adding an implement, you can save your implement after entering the implement's width—but complete all the necessary setup and calibration for optimal performance before running job/task.
• Adding an AC110 Implement - Name and Mount Type
• Adding an AC110 Implement - Implement Settings
• Adding an AC110 Implement - Rate Control Settings Overview
• Calibrating eTurns
When you add an implement, it remains in memory. You must add (a vehicle and) an implement before you can start/run a job/task.
The navigation path to specific implement panels depends on how many implements are current and whether the implements have one boom or multiple booms. The following table describes how to navigate the different button presses.
| Implements/Booms | Navigation Path |
| One implement (single boom) | Menu > Implement Profiles > Current Implement Press Implement Settings to display the Implement Settings panel. |
| One ISOBUS implement (multiple booms) | Menu > Implement Profiles > Current Implement Press Boom List, then press the preferred boom to display the Implement settings panel. |
| One ISOBUS implement and one AC110 implement | AC110 Menu > Implement Profiles > Current Implements > (AC110 implement) Press Implement Settings to display Implement Settings panel. ISOBUS single boom Menu > Implement Profiles > Current Implements > (ISOBUS implement) Press Implement Settings to display Implement Settings panel ISOBUS multiple booms Menu > Implement Profiles > Current Implements > (ISOBUS implement) Press Boom List, then press the preferred boom to display the Implement settings panel. |